Raspberry PI Serial I/O EXPANDER 41901

Description
The Rpi -HUB module from FTDI chip is connected to a Raspberry Pi computer , thus expanding the number of interfaces that can be accessed by a host. The Rpi - HUB module also provides a two-channel interface converter for USB to UART/245FIFO/SPI/I2C/JTAG/GPIO and is intended for use with the Raspberry Pi .
USB 2.0 Hi- Speed ??compatible
A standard USB type A connector pin for connection to the host
USB Hi-Speed ??FT2232H device for USB-Serial/Bitbang communication. The entire USB protocol is handled by the USB module
Built-in USB 2.0 Hi-Speed ??hub controller to support 3 downstream USB ports
External power input connector to power external downstream USB ports with power.
Hibernate Support and operating recording via USB
By default, for two independent UART interfaces .
All I / O pins are 5 V safe for
UART data transmission rate of 300 baud to 12 Mbaud to 3.3 V TTL levels
Synchronous serial ( MPSSE ) data rates up to 30 Mbit / s on JTAG, SPI and I2C
A dual-port USB Connector Type A and a pin header with 0.1 inch to support up to 3 downstream USB ports
Green / red status LED for the USB downstream ports 1 and 2
The LED shows the power status of external downstream USB ports
Integrated EEPROM 93LC56 for FT2232H configuration
UHCI / OHCI / EHCI compatible host controller


Specification
• USB 2.0 Hi-Speed compatible
• One standard USB type A plug to connect to the Host
• USB Hi-Speed FT2232H device for USBSerial/Bit bang communications.
Entire USB protocol handled by USB module
• USB 2.0 Hi-Speed hub controller integrated to
support up to 3 downstream USB ports
• External power input connector available to
supply external downstream USB ports.
• Support for USB suspend and resume
• Defaults to two independent UART interfaces.
• All I/O pins are 5V Safe
• UART data transfer rates from 300 baud to 12
Mbaud at 3.3V TTL levels
• Synchronous Serial (MPSSE) data rates of up to
30Mbps on JTAG, SPI and I2C
• One dual-port USB type A connector and 0.1”
pitch header to support up to 3 downstream USB ports
• Green/Red status LED for downstream USB port 1 & 2.
• LED indicating power supply to external downstream USB ports
• On-board EEPROM 93LC56 for FT2232H configuration
• UHCI / OHCI / EHCI host controller compatible

Package content
1 x Module