Il progetto che andremo a presentarvi ha lo scopo di presentarvi un nuovo prodotto che ci è arrivato da poco e ha da subito attirato molta attenzione: il modulo di ricarica wireless.
Questo dispositivo sta prendendo da poco piede nell'ambito elettronico-informatico proprio perchè promette un passaggio di corrente senza l'ausilio di fili.
In questo caso il progetto è un pò più complesso di quelli presentati ultimamente, dato che si è costruito una scheda apposta per questo dispositivo, una scatola per contenerla e si è utilizzato il cuore di Arduino per processare il tutto: atmel328P.
Componenti e Schema Circuitale:

1x atmel328P
1x matrice led 8x8
1x display LCD 16x2
1x pulsante
1x Sistema di ricarica Wireless
Trasmettitore
_tensione comando alla bobina: onda impulsiva 50v 70Hz
_VDD (alimentazione) : 5/9/12V
_VDD
max : 13,5 V
_dimensione trasmettitore : 17x12x4 mm
Ricevitore
_tensione in output: 5V
_corrente massima: 600mA
_ dimensione Ricevitore: 24x10x3 mm
Funzionamento:
Avvicinando il dispositivo alla sua base di ricarica il sistema si accenderà visualizzando tensione e corrente assobita.
Premendo il pulsante si accendono i led presenti nella matrice modificando la corrente visualizzata al variare del colore rappresentato.
Allontanando il dispositivo dalla base il sistema si spegnerà.
Per qualsiasi dubbio, parere o chiarimento commentate qui!
ENGLISH VERSION
This project was made to show the big potentiality of the wireless charge module.
This device is use to transmit power supply over wireless, without need of any cable.
In this case we didn't use arduino Uno Board, but only the processor (the atmel328P) and we create a dedicated board for this device.
Components and Connection:
1x Atmel 328P
1x 8x8 led matrix
1x push button
1x LCD Display 16x2
1x Wireless Charge System
The wireless Charge System has the following features:
Transmitter
command voltage: pulse 50V 70Hz
VDD(power supply): 5/9/12 V
VDD
MAX: 13,5 Vdc
dimension: 17x12x4 mm
Receiver
output: 5V
max current: 600 mA
dimension: 24x10x3 mm
Overview:
Place near the charge base to turn on the system.
The LCD show the tension and the current.
By pressing the button the LED matrix will turn on, changing the current shown by the color represented
Remove the device from the base to turn it off.
As usual for any question or comment please write below!